Default-Metric (Ipv6 Ospf) - Allied Telesis x510-28GTX Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
- (IP 6 OSPF)
DEFAULT METRIC V

default-metric (IPv6 OSPF)

Overview This command sets default metric value for routes redistributed into the IPv6 OSPF
routing protocol.
The no variant of this command returns IPv6 OSPF to using built-in, automatic
metric translations, as appropriate for each routing protocol.
Syntax default-metric <0-16777214>
no default-metric [<0-16777214>]
Mode Router Configuration
Usage A default metric facilitates redistributing routes even with incompatible metrics. If
the metrics do not convert, the default metric provides an alternative and enables
the redistribution to continue. The effect of this command is that IPv6 OSPF will use
the same metric value for all redistributed routes. Use this command in
conjunction with the
awplus#
Examples
awplus(config)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
Related redistribute (IPv6 OSPF)
commands
C613-50170-01 Rev B
Parameter Description
<1-16777214>
Default metric value appropriate for the specified routing protocol.
redistribute (IPv6 OSPF)
configure terminal
router ipv6 ospf 100
configure terminal
router ipv6 ospf 100
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
command.
default-metric 100
no default-metric
1106