Show Debugging Ipv6 Ospf - Allied Telesis x510-28GTX Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
6
SHOW DEBUGGING IPV OSPF

show debugging ipv6 ospf

Overview Use this command in User Exec or Privileged Exec modes to display which OSPFv3
debugging options are currently enabled.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
Syntax show debugging ipv6 ospf
Mode User Exec and Privileged Exec
awplus#
Example
Output Figure 28-1: Example output from the show debugging ipv6 ospf command
C613-50170-01 Rev B
show debugging ipv6 ospf
OSPFv3 debugging status:
OSPFv3 all packet detail debugging is on
OSPFv3 all IFSM debugging is on
OSPFv3 all NFSM debugging is on
OSPFv3 all LSA debugging is on
OSPFv3 all NSM debugging is on
OSPFv3 all route calculation debugging is on
OSPFv3 all event debugging is on
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
"Getting Started
Guide.
1135