Ipv6 Ospf Network - Allied Telesis x510-28GTX Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
6
IPV OSPF NETWORK

ipv6 ospf network

Overview This command configures the OSPF network type to a type different from the
default for the particular VLAN interface.
The no variant of this command returns the network type to the default for the
particular VLAN interface.
Syntax ipv6 ospf network [broadcast | non-broadcast | point-to-point |
point-to-multipoint]
no ipv6 ospf network
The default is the broadcast OSPF network type for a VLAN interface.
Default
Mode Interface Configuration for a VLAN interface.
Usage This command forces the interface network type to the specified type. Depending
on the network type, OSPF changes the behavior of the packet transmission and
the link description in LSAs.
The following example shows setting the network type to point-to-point on
Example
the VLAN interface vlan1:
awplus#
awplus(config)#
awplus(config-if)#
C613-50170-01 Rev B
Parameter
broadcast
non-broadcast
point-to-multipoint
point-to-point
configure terminal
interface vlan1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Sets the network type to broadcast.
Sets the network type to NBMA.
Sets the network type to point-to-multipoint.
Sets the network type to point-to-point.
ipv6 ospf network point-to-point
1122