Table of Contents
Advertisement
LLDP C
OMMANDS
-
-
LOCATION COORD
LOCATION
ID
location coord-location-id
Overview
Use this command to assign a coordinate location to the ports. The coordinate
location must already exist. This replaces any previous assignment of coordinate
location for the ports. Up to one location of each type can be assigned to a port.
Use the no variant of this command to remove a location from the ports.
Syntax
location coord-location-id <coord-loc-id>
no location coord-location-id [<coord-loc-id>]
Default
By default no coordinate location is assigned to ports.
Mode
Interface Configuration
Usage
The coordinate location associated with a port can be transmitted in Location
Identification TLVs via the port.
Before using this command, configure the location using the following
commands:
•
•
If a coordinate location is deleted using the no variant of the
coord-location identifier
Examples
To assign coordinate location 1 to port1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove a coordinate location from port1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related
lldp med-tlv-select
Commands
location coord-location identifier
location coord-location configuration
show location
C613-50103-01 REV A
Parameter
<coord-loc-id>
location coord-location identifier
location coord-location configuration
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Coordinate location ID, in the range 1 to 4095.
command
command
command, it is automatically removed from all ports.
location coord-location-id 1
no location coord-location-id
location
2345
Advertisement
Table of Contents
