Location Elin-Location-Id - Allied Telesis x310-26FT Command Reference Manual

LLDP C
OMMANDS
- -
LOCATION ELIN LOCATION ID

location elin-location-id

Overview Use this command to assign an ELIN location to the ports. The ELIN location must
already exist. This replaces any previous assignment of ELIN location for the ports.
Up to one location of each type can be assigned to a port.
Use the no variant of this command to remove a location identifier from the ports.
Syntax location elin-location-id <elin-loc-id>
no location elin-location-id [<elin-loc-id>]
Default By default no ELIN location is assigned to ports.
Mode Interface Configuration
Usage An ELIN location associated with a port can be transmitted in Location
Identification TLVs via the port.
Before using this command, configure the location using the
command.
If an ELIN location is deleted using the no variant of one of the
elin-location
Examples To assign ELIN location 1 to port 1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove an ELIN location from port 1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related lldp med-tlv-select
Commands
location elin-location
show location
C613-50103-01 REV A
Parameter
<elin-loc-id>
command, it is automatically removed from all ports.
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
ELIN location identifier, in the range 1 to 4095.
location elin-location-id 1
no location elin-location-id
location elin-location
location
2347