Lldp Commands; Introduction - Allied Telesis x310-26FT Command Reference Manual

55

Introduction

Overview LLDP and LLDP-MED can be configured using the commands in this chapter, or by
using SNMP with the LLDP-MIB and LLDP-EXT-DOT1-MIB (see the
Allied Telesis Enterprise MIBs in AlliedWare
The Voice VLAN feature can be configured using commands in
chapter.
For more information about LLDP, see the
Configuration
LLDP can transmit a lot of data about the network. Typically, the network
information gathered using LLDP is transferred to a Network Management System
by SNMP. For security reasons, we recommend using SNMPv3 for this purpose (see
the
LLDP operates over physical ports only. For example, it can be configured on switch
ports that belong to static or dynamic channel groups, but not on the channel
groups themselves.
Command List •
•
•
•
•
•
•
•
•
•
•
C613-50103-01 REV A

LLDP Commands

Guide.
SNMP Feature Overview and Configuration
"clear lldp statistics" on page 2314
"clear lldp table" on page 2315
"debug lldp" on page 2316
"lldp faststart-count" on page 2318
"lldp holdtime-multiplier" on page 2319
"lldp management-address" on page 2320
"lldp med-notifications" on page 2321
"lldp med-tlv-select" on page 2322
"lldp non-strict-med-tlv-order-check" on page 2325
"lldp notification-interval" on page 2326
"lldp notifications" on page 2327
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Plus).
VLAN Commands
LLDP Feature Overview and
Guide).
Support for
2312