Debug Lldp - Allied Telesis x310-26FT Command Reference Manual

LLDP C
OMMANDS

DEBUG LLDP

debug lldp
Overview This command enables specific LLDP debug for specified ports. When LLDP
debugging is enabled, diagnostic messages are entered into the system log. If no
port list is supplied, the specified debugging is enabled for all ports.
The no variant of this command disables specific LLDP debug for specified ports. If
no port list is supplied, the specified debugging is disabled for all ports.
debug lldp {[rx][rxpkt][tx][txpkt]} [interface [<port-list>]]
Syntax
debug lldp operation
no debug lldp {[rx][rxpkt][tx][txpkt]} [interface
[<port-list>]]
no debug lldp operation
no debug lldp all
Default By default no debug is enabled for any ports.
Mode Privileged Exec
Examples To enable debugging of LLDP receive on ports 1.0.1 and 1.0.6, use the command:
awplus#
To enable debugging of LLDP transmit with packet dump on all ports, use the
command:
awplus#
To disable debugging of LLDP receive on ports 1.0.1 and 1.0.6, use the command:
awplus#
To turn off all LLDP debugging on all ports, use the command:
awplus#
C613-50103-01 REV A
Parameter Description
rx
LLDP receive debug.
rxpkt
Raw LLDPDUs received in hex format.
tx
LLDP transmit debug.
txpkt
Raw Tx LLDPDUs transmitted in hex format.
<port-list>
The ports for which debug is to be configured.
operation
Debug for LLDP internal operation on the switch.
all
Disables all LLDP debugging for all ports.
debug lldp rx interface port1.0.1,port1.0.6
debug lldp tx txpkt
no debug lldp rx interface port1.0.1,port1.0.6
no debug lldp all
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
2316