Port Class; Power Class; Power Priority - Allied Telesis x310-26FT Command Reference Manual

LLDP C
OMMANDS
-
SHOW LLDP LOCAL INFO
Table 55-1: Parameters in the output of show lldp local-info (cont.)
C613-50103-01 REV A
Parameter
Power Via MDI (PoE)

Port Class

Pair Control
Ability
Power Pairs

Power Class

Link Aggregation
Aggregated Port-ID
Maximum Frame Size
LLDP-MED Device
Type
LLDP-MED
Capabilities
Network Policy
VLAN ID
Tagged Flag
Layer-2 Priority:
DSCP Value
Location
Identification
Extended Power Via
MDI (PoE)
Power Source

Power Priority

Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
PoE-capability and current status on the local port.
Whether the device is a PSE (Power Sourcing Entity) or a
PD (Powered Device)
Whether power pair selection can be controlled
Which power pairs are selected for power ("Signal Pairs"
or "Spare Pairs") if pair selection can be controlled
The power class of the PD device on the port (class 0, 1, 2,
3 or 4)
Whether the link is capable of being aggregated and it is
currently in an aggregation.
Aggregated port identifier.
The maximum frame size capability of the implemented
MAC and PHY.
LLDP-MED device type
Capabilities LLDP-MED capabilities supported on the
local port.
List of network policies configured on the local port.
VLAN identifier for the port for the specified application
type
Whether the VLAN ID is to be used as tagged or
untagged
Layer 2 User Priority (in the range 0 to 7)
Diffserv codepoint (in the range 0 to 63)
Location configured on the local port.
PoE-capability and current status of the PoE parameters
for Extended Power-Via-MDI TLV on the local port.
The power source the switch currently uses; either
primary power or backup power.
The power priority configured on the port; either critical,
high or low.
2357