Table of Contents
Advertisement
dummyhead
BF175D/BF200D/BF225D/BF250D
MOTOR INSTALLATION
MOTOR SELECTION
Secure and correct installation is essential for safe boating and good
performance. Follow the installation instructions provided in this
manual.
Improper set-up or pre-deliver service can
cause an unsafe condition that can cause
your customer to be seriously hurt or killed.
Follow the procedures and precautions in this
manual and shop manual carefully.
Before installation, check to be sure that the outboard motor does
not exceed the recommended maximum horsepower for the boat on
which it is to be installed.
Refer to the boat's certification plate for recommended maximum
horsepower. For most applications, the outboard motor should
provide 80% of the recommended maximum horsepower for the
boat. If the certification plate information is not available, contact the
boat dealer or manufacturer.
Refer to the dimensional drawings to be sure there is nothing on the
boat that will interfere with outboard motor tilt up and steering.
The BF175D, BF200D, BF225D and BF250D outboard motors are
designed to be installed on boat transom with the following transom
board thickness.
Boat transom board thickness [1]: 50 – 70 mm (2-2-3/4 in)
General Guidelines
Install the outboard motor on the center [1] of the boat transom [2]
securely and be sure that the boat is well-balanced.
12
[1]
[1]
[2]
Advertisement
Table of Contents
