Advertisement
SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings
Audio Beep at Marker Power
When enabled, the Audio Beep feature emits a repetitive beep sound which
varies in tone pitch and repetition rate to indicate the relative power level of the
active marker. The highest tone pitch and fastest beep rate occurs when the
marker Y-axis position is at the top of the display. Conversely, the lowest pitch
and repetition rate occurs at the bottom of the display. Therefore, it is
important to scale the signals that you intend to measure between the top and
bottom of the screen. Learn more about Scale in
page
Audio Beep can be used with any marker type or function, including
Band/Interval Power. Learn more in
How to use Audio Beep
1. Press Marker
2. Optionally, press
3. Then
Audio Beep does NOT beep when the FieldFox is in Hold mode.
While Audio Beep is ON, press
through the existing markers.
To set FieldFox speaker volume control, press System, then Volume. Learn
more in
Meas UNCAL Error
Meas UNCAL
can NOT display accurate measurement results with the current settings.
Usually, the part of the trace that is inaccurate is shown at –200 dB.
The following situation can produce Meas UNCAL:
— When the ResBW/VBW ratio exceeds 10,000, causing the VBW filter to
216
—
ON
Time Zero is fixed at the left-edge of the screen. A marker in
negative delay resides at this point. This is the vintage behavior.
—
OFF
(default) Time Zero is located at the T-zero indicators. A marker
in negative delay appears to the left of T-zero.
157.
Marker 1 2 3 4 5 6
with Audio Beep. A marker will be created if one does not already exist.
More
Marker Function
>
"Audio" on page
appears in the lower-left corner of the screen when the FieldFox
reach the maximum capacity for averaging.
"Audio" on page
to select an existing marker to use
Audio Beep ON OFF
>
Marker 1 2 3 4 5 6
775.
Keysight N9938-90006 User's Guide
"Scale and Units" on
775.
to toggle Audio Beep
Hide quick links:
Advertisement
Chapters
