Related
ip ftp username
Commands
ip ftp source-interface
Configure an interface's IP address as the source IP address for FTP connections.
Z9500
Syntax
ip ftp source-interface interface
To delete an interface, use the no ip ftp source-interface interface
command.
Parameters
interface
Defaults
The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
114
— sets the user name for the FTP sessions.
Enter the following keywords and slot/port or number
information:
•
For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
•
For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
•
For a tunnel interface, enter the keyword tunnel.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Control and Monitoring