Configuring The Serial Port - Enterasys Vertical Horizon VH-2402S2 Configuration Manual

Configuring the Serial Port

You can access the on-board configuration program by attaching a VT100
compatible device to the switch's serial port. (For more information on
connecting to this port, see "Required Connections" on page 3.) The
communication parameters for this port can be accessed from the Serial
Port Configuration screen shown below and described in the following
table.
Use <TAB> or arrow keys to move, <Space> to scroll options.
Parameter
Management Mode
Baud Rate
Databits
Stopbits
Parity
Time-Out
Auto Refresh
9033820-03
Vertical Horizon Stack Local Management
Serial Port Configuration
Management Mode
Baud rate
Data bits
Stop bits
Parity
Time-Out (in minutes)
Auto Refresh (in seconds) : 5
<APPLY>
Figure 2-12. Serial Port Configuration
Default
Console Mode
Auto
8 bits
1 bit
none
10 minutes
5 seconds
: CONSOLE MODE
: AUTO
: 8
: 1
: NONE
: 10
<OK>
Description
Indicates that the console port settings are for
direct console connection.
The rate at which data is sent between devices.
Options : 2400, 4800, 9600, 19200 bps, and Auto
detection
Sets the databits of the RS-232 port.
Options : 7, 8
Sets the stop bits of the RS-232 port.
Options : 1, 2
Sets the parity of the RS-232 port.
Options : none/odd/even
If no input is received from the attached device
after this interval, the current session is
automatically closed.
Range : 0 - 100 minutes; 0: disabled
Sets the interval before a console session will
auto refresh the console information, such as
Spanning Tree Information, Port Configuration,
Port Statistics, and RMON Statistics.
Range : 5-255 seconds; 0: disabled
<CANCEL>
VH-2402S2 User Interface 21