Default Settings For Router Operation - Enterasys C5G124-24 Configuration Manual

Factory Default Settings
Table 4-1 Default Settings for Basic Switch Operation (continued)
Feature
Spanning Tree topology
change trap suppression
Spanning Tree version
SSH
System baud rate
System contact
System location
System name
Telnet
Telnet port (IP)
Terminal
Timeout
User names
VLAN dynamic egress
VLAN ID
Host VLAN
Not all of the following routing features are available on all platforms. Some routing protocols
require a separate license to become operable. Check the Release Notes for your specific platforms
for details.
Table 4-2 Default Settings for Router Operation
Feature
Access groups (IP security)
Access control lists
Area authentication (OSPF)
Area default cost (OSPF)
Area NSSA (OSPF)
Area range (OSPF)
ARP table
ARP timeout
Authentication key (RIP and OSPF)
Authentication mode (RIP and OSPF)
Dead interval (OSPF)
Disable triggered updates (RIP)
Distribute list (RIP)
DVMRP
4-4 System Configuration
Default Setting
Enabled.
Set to mstp (Multiple Spanning Tree Protocol).
Disabled.
Set to 9600 baud.
Set to empty string.
Set to empty string.
Set to empty string.
Enabled inbound and outbound.
Set to port number 23.
CLI display set to 80 columns and 24 rows.
Set to 5 minutes.
Login accounts set to ro for Read-Only access; rw for Read-Write access;
and admin for Super User access.
Disabled on all VLANs.
All ports use a VLAN identifier of 1.
Default host VLAN is 1.
Default Setting
None configured.
None configured.
Disabled.
Set to 1.
None configured.
None configured.
No permanent entries configured.
Set to 14,400 seconds.
None configured.
None configured.
Set to 40 seconds.
Triggered updates allowed.
No filters applied.
Disabled. Metric set to 1.