Show Ip Pimsm Rphash; Show Ip Pimsm Rp Output Details - Enterasys SECURESTACK C3 Configuration Manual

Defaults
None.
Mode
Any router mode.
Examples
This example shows how to display the RP set for a specific group address.
C3(su)->router> show ip pimsm rp 224.0.0.0 240.0.0.0
Group
Address
---------
224.0.0.0 240.0.0.0
Table 20‐12 provides an explanation of the command output.
Table 20-12 show ip pimsm rp Output Details
Output Field
Group Address
Group Mask
Address
Hold Time
Expiry Time
Component
C-RP Priority
This example shows how to display the candidate RPs for each group address.
C3(su)->router> show ip pimsm rp candidate
Group Address
--------------- --------------- ---------------
224.0.0.0

show ip pimsm rphash

Displays the Rendezvous Point router that will be selected from the set of active RP routers. The
RP router, for the group, is selected by using the hash algorithm defined in RFC 2362.
Syntax
show ip pimsm rphash group-address
Group Mask Address
---------- -----------
192.168.30.2
What it displays
The address of the group for which the RP set is displayed.
The mask of the group address.
The IP address of the RP.
The hold time of the RP.
The minimum time remaining before the RP will be declared down.
A number which uniquely identifies the component. Each protocol instance
connected to a separate domain should have a different index value.
The candidate-RP priority of the RP.
CANDIDATE RP TABLE
Group Mask
240.0.0.0
RP SET TABLE
Hold Time Expiry Time Component C-RP Priority
(hh:mm:ss) (hh:mm:ss)
---------- ----------- --------- -----------
00:02:15 00:02:30
Address
192.168.30.2
SecureStack C3 Configuration Guide 20-57
show ip pimsm rphash
1 0