Table of Contents
Advertisement
ip address
Example
This example shows how to display configuration information for VLAN 1:
B3(su)->router#show ip interface vlan 1
Vlan 1 is Admin DOWN
Vlan 1 is Oper DOWN
Primary IP Address is 192.168.10.1
Frame Type Ethernet
MAC-Address 0001.F45C.C993
Incoming Accesslist is not set
Outgoing AccessList is not set
MTU is 6145 bytes
ARP Timeout is 1 seconds
Direct Broadcast Disabled
Proxy ARP is Disabled
Table
17‐1 provides an explanation of the command output.
Table 17-1 show ip interface Output Details
Output
Vlan N
IP Address
Frame Type
MAC-Address
Incoming Access
List
Outgoing Access
List
MTU
ARP Timeout
Direct Broadcast
Proxy Arp
ip address
Use this command to set, remove, or disable a primary or secondary IP address for an interface.
The no form of this command removes the specified IP address and disables the interface for IP
processing.
Syntax
ip address ip-address ip-mask [secondary]
no ip address ip-address ip-mask
17-4 IP Configuration
What It Displays...
Whether the interface is administratively and operationally up or down.
Interface's IP address and mask. Set using the ip address command as described in
"ip
address" on page 17-4.
Encapsulation type used by this interface. Set using the arp command as described
in "arp" on page 17-8.
MAC address mapped to this interface.
Whether or not an access control list (ACL) has been configured for ingress on this
interface using the commands described in "" on page 20-70.
Not applicable.
Interface's Maximum Transmission Unit size.
Duration for entries to stay in the ARP table before expiring. Set using the arp
timeout command as described in
Whether or not IP directed broadcast is enabled. Set using the ip directed-broadcast
command described in
"ip
Whether or not proxy ARP is enabled or disabled for this interface. Set using the ip
proxy arp command as described in
Mask 255.255.255.0
"arp
timeout" on page 17-10.
directed-broadcast" on page 17-11.
"ip
proxy-arp" on page 17-9.
Advertisement
Table of Contents
