Show Ip Pimsm Rp Output Detail - Enterasys SecureStack C2 Configuration Manual

show ip pimsm rp
Parameters
group‐address
group‐mask
all
candidate
Defaults
None.
Mode
Any router mode.
Examples
This example shows how to display the RP set for a specific group address.
C2(su)->router> show ip pimsm rp 224.0.0.0 240.0.0.0
Group
Address
---------
224.0.0.0 240.0.0.0
Table 17‐12 provides an explanation of the command output.
Table 17-12 show ip pimsm rp Output Detail
Output
Group Address
Group Mask
Address
Hold Time
Expiry Time
Component
C-RP Priority
This example shows how to display the candidate RPs for each group address.
C2(su)->router> show ip pimsm rp candidate
Group Address
--------------- --------------- ---------------
224.0.0.0
17-52 IPv4 Routing Protocol Configuration
The multicast group IP address.
The multicast group address subnet mask.
For all known group addresses.
Display PIM‐SM candidate‐RP table information.
Group Mask Address
---------- -----------
192.168.30.2
What it displays
The address of the group for which the RP set is displayed.
The mask of the group address.
The IP address of the RP.
The hold time of the RP.
The minimum time remaining before the RP will be declared down.
A number which uniquely identifies the component. Each protocol instance
connected to a separate domain should have a different index value.
The candidate-RP priority of the RP.
CANDIDATE RP TABLE
Group Mask
240.0.0.0
RP SET TABLE
Hold Time Expiry Time Component C-RP Priority
(hh:mm:ss) (hh:mm:ss)
---------- ----------- --------- -----------
00:02:15 00:02:30
Address
192.168.30.2
1 0