Cli Command Modes; Using Webview - Enterasys Matrix E1 1G694-13 Configuration Manual

Startup and General Configuration

CLI Command Modes

3.1.3 CLI Command Modes
Each command description in this guide includes a section entitled "Command Mode" which states
whether the command is executable in Read-Write or Read-Only mode. Users with Read-Only
access will only be permitted to view Read-Only (show) commands. Users with Read-Write access
will be able to modify all modifiable parameters in set and show commands, as well as view
Read-Only commands.
3.1.4

Using WebView

NOTE: This guide describes configuring and managing the Matrix E1 device using CLI
commands. For details on using WebView (Enterasys Networks' embedded web server)
for configuration and management tasks, refer to the Matrix E1 1G694-13 WebView
User's Guide.
By default WebView is enabled on TCP port number 80 of the Matrix E1 device. You can verify
WebView status, enable or disable WebView, and reset the WebView port as described below.
Displaying WebView status:
To display WebView status, enter show webview at the CLI command prompt.
This example shows that WebView is enabled on TCP port 80, the default port number.
Matrix>show webview
Webview is currently enabled on port 80.
Enabling / disabling WebView:
To enable or disable WebView, enter set webview {enable | disable} at the CLI command prompt.
This example shows how to enable WebView.
Matrix>set webview enable
Webview enabled.
Setting the WebView port:
To set a different TCP port through which to run WebView, enter set webview port webview_port
at the CLI command prompt. Webview_port must be a number value from 1 to 65535 specifying
the WebView TCP port.
3-4 Matrix E1 Series (1G694-13) Configuration Guide