Using And Configuring Webview; Purpose; Commands - Enterasys C3G124-24 Configuration Manual

Using and Configuring WebView

Switch command, super-user, if security profile = c2
Usage
When using the clear config command to clear configuration parameters in a stack, it is important
to remember the following:
• Use clear config to clear configuration parameters without clearing stack unit IDs. This
command WILL NOT clear stack parameters and avoids the process of re-numbering the
stack.
• Use clear config all when it is necessary to clear all configuration parameters, including stack
unit IDs (if applicable) and switch priority values.
• Use the clear ip address command to clear the IP address.
Configuration parameters and stacking information can also be cleared on the master unit only by
selecting option 10 (restore configuration to factory defaults) from the boot menu on switch
startup. This selection will leave stacking priorities on all other units, if applicable.
Example
This example shows how to clear configuration parameters (including stacking parameters, if
applicable):
C3(su)->clear config all
Using and Configuring WebView

Purpose

By default, WebView (The Enterasys Networks embedded web server for switch configuration
and management tasks) is enabled on TCP port number 80 on the Enterasys C3 switch. You can
verify WebView status, and enable or disable WebView using the commands described in this
section. WebView can also be securely used over SSL port 443, if SSL is enabled on the switch. By
default, SSL is disabled.
To use WebView, type the IP address of the switch in your browser. To use WebView over SSL,
type in https:// then the IP address of the switch. For example, https://172.16.2.10.

Commands

For information about...
show webview
set webview
show ssl
set ssl
3-50 Basic Configuration
Refer to page...
3-51
3-51
3-52
3-52