FABIA 2000
1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
15 – Cylinder Head, Valve Gear
15-1
Removing and installing cylinder head
Summary of components
–
Testing compression pressure ⇒ Chap. 15-2
Note
Removing and installing intake manifold: ⇒ 1.0/37; 1.4/44; 1.4/50 engine - fuel injection; Rep. Gr. 24
♦
Removing and installing exhaust manifold ⇒ Chapter 26-1
♦
♦
If the cylinder head is replaced, the system must be completely filled with fresh coolant.
1 - 3 Nm
2 - Seal
replace
3 - Cylinder head bolt
moisten with oil before
screwing in
tightening order and tighten-
ing torque ⇒ 15-1 page 4
4 - Washer
5 - Lifting eye - on the left
6 - Rocker arm shaft
removing and installing rock-
er arms ⇒ Chapter 15-3
performing basic setting of
hydraulic valve clearance
compensation ⇒ Chap. 15-2
7 - Bracket
for ignition terminal
8 - Shim
9 - 23 Nm
do not tighten fully until cylin-
der head bolts have been
tightened
10 - 20 Nm
self-locking, replace
do not tighten fully until cylin-
der head bolts have been
tightened
11 - 20 Nm
wet with -AMV 105 500-
(Loctite 242) before screwing
in
do not tighten fully until cylinder head bolts have been tightened
12 - Bracket
for generator support
13 - Cylinder head gasket
Observe installation position; with part no. marking faces up
replace
14 - Cylinder head
check for distortion ⇒ Fig. 1 in 15-1 page 2
Edition 09.03
S00.5305.04.20
Removing and installing cylinder head
15
15-1
1
page