Removing And Installing Cylinder Head Cover - Skoda Octavia Workshop Manual

15
------------ 15-2 ------------
Cylinder Head, Valve Gear
Removing and installing cylinder
head cover
l Engine installed.
Notes:
♦ Hose connections are secured with screw-
type, spring strap or collar clamps.
♦ Always replace collar clamps by spring strap
clamps or screw-type clamps.
♦ Fuel hoses at the engine must be secured
only with spring strap clamps. It is not
permitted to use collar or screw-type clamps.
♦ It is recommended to use the pliers for spring
strap clamps for removing and installing such
clamps.
Special tools, testers and aids required
♦ Torque wrench 5...50 Nm
(e.g. V.A.G 1331)
♦ Pliers for spring strap clamps
♦ Cable straps
Removing
- Switch off ignition (if not already off) and
disconnect earth strap at the battery.
Note:
If vehicle is fitted with radio set with anti-theft
coding, determine code, if necessary, first of all.
- All the cable straps which have been
detached or cut open when removing, should
be fitted on again at the same point when
installing.
Models ä 07.97
- Detach throttle cable at the throttle valve
control unit and release support at the intake
manifold (do not remove locking detent).
- Unclip throttle cable and ignition cables from
the ignition cable guide.
K - Remove engine trim panel -arrows-.
OCTAVIA
Edition 10.99
S00.5104.53.20