Separating Brake Pedal From Brake Servo - Skoda Kodiaq 2017 Workshop Manual

– Install the electric wiring harness -2- so that it is not then trap‐
ped between pedal and bearing bracket.
Tightening torques - summaries of components
Note
Replace bolts / nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ ⇒ "4.1.2 Summary of components - brake pedal, right-hand
drive", page 73
♦ Impact absorber ⇒ General body repairs, interior; Rep. gr.
70 ; Dash panel cross member
♦ Knee airbag ⇒ General body repairs, interior; Rep. gr. 69 ;
Knee airbags; Removing and installing knee airbag with igniter
♦ Accelerator pedal ⇒ Rep. gr. 20 ; Accelerator control
♦ Wiper motor with linkage ⇒ Electrical system; Rep. gr. 92 ;
Windscreen wiper system; Summary of components - wind‐
screen wiper system
4.3 Separating brake pedal from brake ser‐
vo
Special tools and workshop equipment required
♦ Release tool - T10159A- or -T10159B-
– Press the brake pedal towards the brake servo unit and hold
it in position.
2 - Plunger rod
3 - Retaining lugs
– Insert release tool - T10159A- or -T10159B- and pull it in the
direction of the driver's seat while counterholding the brake
pedal (the pedal must not move backwards during this oper‐
ation). This pushes the retaining lugs -3- of the mount off the
ball head of the push rod -2-.
The fig. shows the separation of the brake pedal from the brake
servo unit with the foot controls removed for clarity.
– Pull release tool - T10159A- or -T10159B- and brake pedal
together towards the driver's seat. (This causes the brake
pedal to be drawn off the ball head of the push rod).
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
79
4. Brake pedal