Removing And Installing Front Sealing Flange - Skoda Octavia Workshop Manual

OCTAVIA
Edition 04.03
S00.5104.56.20
Crank Assembly
K - Check installation dimension in three points
of the drive plate and determine mean value.
Specified value -a- 19.5….21.1 mm
Note:
The measurement is made through the hole of
the drive plate to the milled surface of the cylin-
der block.
If the specified value is not reached:
K - Remove drive plate and use a suitable com-
pensating washer -2-.
If the specified value is reached:
- Lock drive plate with counterholder MP 1-221
and tighten the new bolts -3- to 60 Nm and
torque a further 90° (1/4 turn).
Removing and installing front seal-
ing flange
Special tools, testers and aids required
♦ Guide sleeve T10053/1
♦ Counterholder T30004
♦ Counterholder MP 1-310
♦ Silicone sealant D176 404 A2
Removing
- Removing ribbed V-belt and tensioning de-
vice ⇒ page 13-1.
- Removing toothed belt
⇒ page 13-5.
13
------------ 13-15 ------------