FABIA 2000
1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
10 – Removing and Installing Engine
10-1
Removing and Installing
Engine
Special tools, test and measuring equipment and
auxiliary items required
♦
Workshop crane (e.g. -V.A.G 1202 A-)
♦
Catch pan (e.g. -V.A.G 1306-)
♦
Torque wrench 5 to 50 Nm (e.g. -V.A.G 1331-)
♦
Torque wrench 40 to 200 Nm (e.g. -V.A.G 1332-)
♦
Pliers for spring strap clips
♦
Engine mount -MP 1-180-
♦
Assembly stand -MP 9-101-
♦
Lifting device -MP 9-201-
♦
Grease -G 000 100-
♦
Hot screw paste -G 052 112 A3-
♦
Wire
♦
Adhesive tape
Removing engine
Note
♦
The engine is removed towards the front together with
the gearbox.
Supporting points for lift platform ⇒ Inspection and
♦
Maintenance.
♦
The hose connections are secured with screw-type
clips, spring-type clips or clamp-type clips. Always re-
place warm-type clamps with spring strap clips or
warm-type clamps.
♦
Fuel hoses at the engine must only be secured with
spring-type clips. The use of clamp-type or screw-type
clips is not allowed.
♦
Use pliers for spring strap clips to fit the spring strap
clips.
♦
Pay attention to the correct assignment of the connec-
tors, if necessary mark.
Procedure
–
On models fitted with a coded radio set, pay attention
to the coding; determine if necessary.
–
Disconnect the earth strap from the battery with the ig-
nition off.
–
Remove noise insulation -arrows-.
–
Unscrew the drive shaft to the right and left of the
gearbox.
–
Raise drive shafts and secure.
Edition 02.02
S00.5305.03.20
Removing and Installing Engine
10
S10-0135
10-1
1
page