Repairing Valve Gear; Removing And Installing Camshaft - Skoda FABIA 2000 Workshop Manual

FABIA 2000 1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
15-3

Repairing valve gear

Removing and installing camshaft

1 - Tappet rod
pay attention to correct in-
stallation position
do not interchange
2 - Hydraulic tappets
with hydraulic valve clear-
ance compensation
check ⇒ 15-3 page 3
use auxiliary tool to pull out
of cylinder block ⇒ Fig. 1 in
15-3 page 1
do not interchange
lay aside with contact sur-
face facing down
oil contact surface
3 - Cylinder block
Removing and installing cyl-
inder block ⇒ Chap. 15-1
Removing and installing tim-
ing gear cover and sprockets
⇒ Chap. 13-2
4 - O-ring
5 - Camshaft position sensor
-G163-
6 - 8 Nm
7 - Camshaft
with timing segment for cam-
shaft position sensor -arrow-
Camshaft setting ⇒ Fig. 2 in
15-3 page 2
8 - Woodruff key
check tightness
9 - Retaining plate of camshaft
10 - 5 Nm
Fig. 1: Removing hydraulic tappet
–
Make auxiliary tool (wire) -2- as shown in illustration.
-a- 1.8 to 1.9 mm
–
Inset shop-made tool -2- in the tappet bore -1-, tilt
slightly and pull tappet out of the guide in the cylinder
block.
Edition 03.01
S00.5305.02.20
1
10
Repairing valve gear
2 3
7
8
9
S15-0149
1
2
a
S15-0130
15-3
15
4
5
6
1
page