Starting; Starting The On-Board - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)

6.7 Starting

6.7 Starting

6.7.1 Starting the On-board

There are two methods used to start the PLC On-board.
 Start from the Mitsubishi Electric standard screen
There is a [Ladder Monitor] menu on the save screen in the Mitsubishi Electric standard screen. (area inside the red lines in
the following diagram)
Selecting this menu starts the PLC On-board and displays the main screen.
 Start by pressing the [F0] key
Pressing the [F0] key when the bit selection parameter that enables the PLC On-board is set starts the PLC On-board and
displays the main screen.
IB-1501614-B 308