Writing And Reading Parameters To Cnc Controller - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
5 Peripheral Development Environment (GX Works2)
5.5 Common Items

5.5.8.6 Writing and Reading Parameters to CNC Controller

To create sequence programs in multi-program method, parameter files must be written to the CNC controller. They can be
read from the CNC controller to be used on GX Works2.
They can be read and written in the same way as reading and writing sequence programs.
(1) Start the operation screen by the following operation on GX Works2.
[Online] -> [Write to PLC]/[Read from PLC]
(2) Select write/read parameter [PLC/Network/Remote Password/Switch Setting], and click [Execute] on the Online Data
Operation screen.
Use [Remote Operation] under [Related Functions] to instruct the PLC to RUN or STOP.
Note
 [Program Memory/Device Memory] is the only valid option for [Target Memory Setting].
IB-1501614-B 96