M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.8 Ending the PLC on-board and Transitioning to the Mitsubishi Electric Standard Screen
6.8 Ending the PLC on-board and Transitioning to the Mitsubishi Electric
Standard Screen
6.8.1 Ending the PLC On-board
There is no end menu in the PLC on-board. For this reason, to end the PLC on-board, transition to the Mitsubishi Electric
standard screen or turn OFF the power to the NC.
6.8.2 Transitioning to the Mitsubishi Electric Standard Screen
6.8.2.1 Method to Transition to the Mitsubishi Electric Standard Screen
The following table describes the method used to transition from the PLC on-board to the Mitsubishi Electric standard screen.
Method to transition to the Mitsubishi Electric standard screen
Press the [MONITOR], [SET UP], [EDIT], [DIAGN], or [MAINTE] key on the NC hardware keyboard to transition to the
screen corresponding to the Mitsubishi Electric standard screen.
Press the [OPERATE], [ARRANGE], [EDIT], [DIAGNOSIS], or [SAVE] key on the PLC on-board software keyboard to
transition to the screen corresponding to the Mitsubishi Electric standard screen.
309
IB-1501614-B