Mitsubishi Electric M800VW Series Manual page 411

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.13 NC File Operation Menus
(4) After selecting data, press the [EXECUTE] menu key. The PLC data selected in the list is read from the external device
and then the PLC data with the same name in the NC is overwritten.
If a password to protect against read or read and write has been registered to the selected files, the password cancel
screen pops up.
Enter the password to temporarily cancel the password. If the password is temporarily cancelled, processing will continue.
Refer to "Canceling File Passwords" for information on entering and clearing passwords.
After the password is cleared, the operation to the PLC on-board is in the password cancel state. If necessary, enable the
password lock state again by any of the following methods:
 Restart the NC
 Execute the password lock for all data (Refer to "Locking the password for all data" in "6.13.11.7 Deleting Passwords"
for the methods.)
IB-1501614-B 386