Reading Label Setting From Cnc Controller; Operation Procedure - Mitsubishi Electric M800VW Series Manual

Plc development

Hide thumbs Also See for M800VW Series:

Table of Contents

M800V/M80V Series PLC Development Manual

5 Peripheral Development Environment (GX Works2)

5.10 Creating Label

5.10.6 Reading Label Setting from CNC Controller

This section describes how to read label setting from the CNC controller to GX Works2 (particularly restrictions and operation

specific to this CNC).

(1) Start the operation screen by the following operation on GX Works2.

[Online] -> [Read from PLC]

(2) After selecting [Program Memory/Device Memory] from [Target Memory Setting] on the following screen, select "GX

Works2 (Simple project)", and click [Execute].

 [Program Memory/Device Memory] is the only valid option for [Target Memory Setting].

 Click [Refresh] before reading data.

 For details on read parameters before reading symbolic information, refer to "5.5.8.6 Writing and Reading Parameters

to CNC Controller".

 When symbolic information is read, sequence programs and FB are also read as well as labels.

IB-1501614-B