Closing The Delete Data Popup Screen - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.13 NC File Operation Menus
If PLC data is deleted while the PLC is running, a message confirming whether or not to pause the PLC is displayed. Select
[YES] to stop the PLC and continue deleting the PLC data. If [NO] is selected, an error occurs since the PLC is not stopped
and the error message is displayed. (Refer to "Abnormal operation")
If the PLC stops, a message displays to confirm whether or not to restart the PLC immediately after data has been deleted.
Select [YES] to continue running the PLC, or select [NO] to keep the PLC stopped.
Abnormal operation
This information describes the details of error messages displayed on the delete data popup screen and the corrective action
thereof.
Error message
A data name has not been entered. En-
ter a data name.
A file was specified which does not ex-
ist in the NC.
Data cannot be deleted because the
PLC is running. Execute again after the
PLC stops.

6.13.6.7 Closing the Delete Data Popup Screen

Use any of the following methods to close the delete data popup screen.
Methods to close the screen
Delete PLC data.
Press the [CLOSE] menu key.
Press the left arrow key.
Press the [ESC] key on the software keyboard.
IB-1501614-B
Error details
This is displayed when the [DELETE]
menu key is pressed while the data
name input field is still blank.
This is displayed when the [DELETE]
menu key is pressed after specifying a
data type or data name in the data name
input field that is not stored in the NC.
This is displayed when trying to delete
data without stopping the PLC.
364
Remedy
Enter a valid data name before press-
ing the [DELETE] menu key.
Press the [DELETE] menu key after
specifying a data type or data name in
the data name that is stored in the NC.
Delete data when the PLC is not run-
ning.