Operation Of Key Presses; Moving The Cursor - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.15 Ladder Menus

6.15.2.4 Operation of Key Presses

The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key
Right arrow key
Monitor
Ladder Symbol 1
Ladder Symbol 2
Find
Step No. search
Convert Ladder
Undo
Switch Program
Contact Coil Usage List
List of used devices
Check Program
Comment ON/OFF
Cancel edit ladder
Zoom Display
Overwrite/Insert

6.15.2.5 Moving the Cursor

Refer to "6.15.1.6 Moving the Cursor".
IB-1501614-B
Operation
This transitions to the main screen.
First page of the menu: Transitions to the second page of the menu.
Second page of the menu: Transitions to the first page of the menu.
This transitions to the monitor menu.
This also starts the ladder monitor.
This transitions to the ladder symbol 1 menu.
This transitions to the ladder symbol 2 menu.
This displays the find popup screen.
This opens the Find Step No. popup screen.
This converts ladders not yet converted and edits details.
This returns to the unconverted ladder to the last previous state.
This displays the select program screen.
This opens the contact coil usage list popup screen.
This opens the list of used devices popup screen.
This opens the check program popup screen.
This turns the device comment display on and off.
This cancels the unconverted ladder and returns it to the state be-
fore any edits were made.
This switches the screen magnification of the ladder screen in this
order: Reduced -> Standard -> Enlarged -> Reduced.
This switches the edit mode between overwrite and insert mode.
440