M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.13 NC File Operation Menus
6.13.10.4 Enabled/Disabled State of Menu Keys
The menu keys displayed on the PLC RUN/STOP popup screen are always enabled.
6.13.10.5 Operation of Key Presses
The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key
Yes
No
Close
6.13.10.6 Changing the PLC State for the Specified Project
To run
(1) Press the [YES] menu key to run the PLC for the specified project. PLC may not run depending on the ladder status,
parameter settings, or other factors.
To stop
(1) Press the [YES] menu key to stop the PLC for the specified project.
6.13.10.7 Closing the PLC RUN/STOP Popup Screen
Use any of the following methods to close the PLC RUN/STOP popup screen.
Methods to close the screen
Press the [YES] menu key.
Press the [NO] menu key.
Press the [CLOSE] menu key.
Press the left arrow key.
Press the [ESC] key on the software keyboard.
IB-1501614-B
Refer to "6.13.10.7 Closing the PLC RUN/STOP Popup Screen".
Refer to "6.13.10.6 Changing the PLC State for the Specified Project".
Refer to "6.13.10.7 Closing the PLC RUN/STOP Popup Screen".
Refer to "6.13.10.7 Closing the PLC RUN/STOP Popup Screen".
374
Operation