M800V/M80V Series PLC Development Manual
5 Peripheral Development Environment (GX Works2)
5.5 Common Items
5.5.7 Reading Data from CNC Controller
Read data in the CNC controller to GX Works2 to edit them. This section describes how to read data from the CNC controller.
(1) Start the operation screen by the following operation on GX Works2.
[Online] -> [Read from PLC]
(2) Select the file to be read on the following screen, and click [Execute].
To read individual files, select files to be read.
To read parameters and sequence programs, click [Parameter+Program].
To read all files, click [Select All].
Note
[Program Memory/Device Memory] is the only valid option for [Target Memory Setting].
Device memory is not written on the CNC controller. Remove the check of "Device Memory".
89
IB-1501614-B