Status During Screen Displays; Operation Of Key Presses; Formatting The Temporary Memory Area In The Nc; Closing The Format Popup Screen - Mitsubishi Electric M800VW Series Manual
Plc development
Hide thumbs
Also See for M800VW Series:
- Connection and set up manual (696 pages) ,
- Programming manual (968 pages)
Table of Contents
Advertisement
M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.13 NC File Operation Menus
6.13.8.5 Status during Screen Displays
The following table describes the status when displaying the format popup screen.
Item name
Create default data after formatting
6.13.8.6 Operation of Key Presses
The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key
Yes
No
Default Data
Close
6.13.8.7 Formatting the Temporary Memory Area in the NC
Normal operation
(1) Press the [DEFAULT DATA] menu key to select whether or not to create the default data after formatting.
(2) Press the [YES] menu key to format the temporary memory area. If the create default data setting is configured, the
default data is created after formatting. After the process is complete, the format popup screen closes.
Abnormal operation
This information describes the details of error messages displayed on the format popup screen and the corrective action
thereof.
Error message
Write executions cannot be performed
because the PLC is running. Execute
again after the PLC stops.
6.13.8.8 Closing the Format Popup Screen
Use any of the following methods to close the format popup screen.
Methods to close the screen
Format the memory.
Press the [CLOSE] menu key.
Press the left arrow key.
Press the [ESC] key on the software keyboard.
IB-1501614-B
This is displayed with the check box not selected.
Hidden when operation mode of the project is GX Works2.
Refer to "6.13.8.8 Closing the Format Popup Screen".
Refer to "6.13.8.7 Formatting the Temporary Memory Area in the NC".
Closes the format popup screen and transitions to the file operation screen.
Selects the selection field to create the default data or changes the selection to
create the default data.
Refer to "6.13.8.8 Closing the Format Popup Screen".
Error details
This is displayed when trying to format
memory without stopping the PLC.
370
Display state
Operation
Remedy
Format memory when the PLC is not
running.
Advertisement
Table of Contents
