M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.20 Software Keyboard
Key
The operation of each key must be supported by the processing performed for the corresponding input parameter.
If not supported, there is no resulting operation from pressing these buttons.
Only the cursor keys, the tab key, the reverse tab key, the "PgUp" key, and the "PgDn" key can issue repeatedly by press-
ing and holding the keys.
This changes the input mode from overwrite to insert and from insert to overwrite.
Pressing the [Insert] key issues the command to the corresponding input parame-
ter.
This deletes one character before the cursor.
Pressing the [Delete] key issues the command to the corresponding input param-
eter.
This deletes all data input into the corresponding parameter.
Pressing the [Shift + Home] keys issues the command to the corresponding input
parameter.
These move the cursor. Press the cursor keys issues the command to the corre-
sponding input parameter.
Pressing the TAB key issues the command to the corresponding input parameter.
Pressing the Shift + TAB keys issues the command to the corresponding input pa-
rameter.
This switches from the PLC on-board to the operation screen in the Mitsubishi
Electric standard screen.
This switches from the PLC on-board to the set up screen in the Mitsubishi Electric
standard screen.
This switches from the PLC on-board to the edit screen in the Mitsubishi Electric
standard screen.
This switches from the PLC on-board to the diagnosis screen in the Mitsubishi
Electric standard screen.
This switches from the PLC on-board to the maintenance screen in the Mitsubishi
Electric standard screen.
581
Operation
IB-1501614-B