M800V/M80V Series PLC Development Manual
5 Peripheral Development Environment (GX Works2)
5.12 File Password Function
5.12.7.4 Temporary Unlock of File Password
To work with a password-protected file on GX Works2 for the following operations, temporarily unlock the file password. The
temporary unlock of a file password is achieved by inputting the registered file password for verification and temporarily
disable unlock for file operation. If the password verification fails, you cannot operate the file.
For instance, when read-protecting a program file with password on a certain session of GX Works2, and then reading from
PLC on another session of GX Works2, temporarily unlock the file password by verifying it.
Temporary password unlock is valid only in the GX Works2 program on which the file password is unlocked. To work with a
file on a separately started session of GX Works2, temporarily unlock the file password again.
Temporary password unlock is valid until the GX Works2 program in which the file password was unlocked is ended.
Operation on GX Works2
[Online] -> [Read from PLC]
[Online] -> [Verify with PLC]
[Online] -> [Write to PLC]
[Online] -> [Delete PLC data]
A file password is temporarily unlocked as follows.
In this example, the password setting file is already stored in the CNC.
Start
Password
unlock
Select [Online] ->
[Password/Keyword] ->
[Disable]
(Perform only once after
starting GX Works2)
Select password setting
file, input the file password
to temporarily unlock
Select either Read from
PLC, Verify with PLC, Write
to PLC, or Delete PLC Data
End
Unlock password required/not required
When a file password to prohibit read is set, the password needs to be tem-
porarily unlocked.
When file password for Read/Write Protection or Write Protection is set, tem-
porary password unlock is required.
225
IB-1501614-B