Mitsubishi Electric M800VW Series Manual page 547

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.17 Device Menus
Screen display items
The following table describes the screen display items on the trace count setup screen.
Item name
Connected NC name
Current project No.
Current project label
Alarm message
Left arrow key
Software keyboard
Total
After trigger
Trace repeat
Enabled/disabled state of menu keys
The menu keys displayed on the trace count setup screen are always enabled.
Status during screen displays
The following table describes the status when the trace count setup screen is displayed.
Item name
Total
After trigger
Trace repeat
Operation of key presses
The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key
Total
After trigger
Trace repeat
Setting
Close
IB-1501614-B
This displays the name of the connected NC.
This displays the current project number.
This displays the project label.
Alarm messages are displayed when alarms occur.
This is displayed when enabled.
This is displayed only when parameters are enabled.
This displays the total number of traces.
This displays the number of traces after trigger.
This displays the trace repeat status.
1024 is displayed.
512 is displayed.
This selects the [NO] option.
Refer to "Closing the trace count setup screen".
The focus is applied to the Total.
The focus is applied to the After trigger.
The focus is applied to the Trace repeat.
This changes the Trace repeat selection when the focus is already applied.
Refer to "Trace count setup".
Refer to "Closing the trace count setup screen".
Display state
Operation
Operation
522