M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.13 NC File Operation Menus
6.13.13.7 Operation of Key Presses
The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key
Select
Close
6.13.13.8 Selecting Updating Version Data
(1) Press the [LIST] menu key to move the focus to the list. Use the up and down arrow keys to select the external device
where the updating version data is stored and press the [INPUT] key or the [SELECT] menu key.
(2) When you press the [INPUT] key or the [SELECT] menu key after selecting "VERSION UP DATA" with the up and down
arrow keys, the select version up data popup screen closes and the PLC version up screen appears again. PLC version
up screen lists the sequence programs, PLC messages, device comments and parameters in the tree view, which are the
results of the comparison between each PLC data stored in the selected updating version data and those stored in the
NC.
6.13.13.9 Closing the Select Version Up Data Popup Screen
Use any of the following methods to close the select version up data popup screen.
Methods to close the screen
Select the updating version data and then press the [SELECT] menu key.
Press the [CLOSE] menu key.
Press the left arrow key.
Press the [ESC] key on the software keyboard.
This closes the select version up data popup screen.
Refer to "6.13.13.8 Selecting Updating Version Data".
This closes the PLC version up screen.
393
Operation
IB-1501614-B