Trace File Read Screen - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.17 Device Menus

6.17.4.10 Trace File Read Screen

Outline
This displays a list of the trace files in the specified project, and reads the specified trace file.
NC (On-board)
On-board trace files
Read data
Write data
Note
(1) The trace conditions are retained in the NC at the start of tracing, and they are retained even if the NC power is OFF.
The trace results are discarded when the NC power is turned OFF.
(2) Reading or writing the trace files are disabled during a trace.
(3) The trace files of the trace conditions, which were created by GX Developer and are not supported with Mitsubishi Electric
CNC, cannot be read.
(4) The trace files that were created in different projects can be read, however, since the size and device range checks are
performed at the trace execution, if the trace file is either the size over or out of the device range, an error message
appears and the trace cannot be executed.
(5) Trace files of GX Works2 projects cannot be input.
IB-1501614-B
Read
Trace conditions Number of traces, trace points, trigger points, trace data, etc.
Trace results Trace data of the bit device and word device
Trace files of GX Developer projects
or trace files written by On-board
(Note) The format between GX Developer and the On-board are different.
548
External device
GX Developer project
On-board trace files