M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.15 Ladder Menus
To confirm the abbreviated label name, put the cursor on the target label and press the "INPUT" key, to display the find popup
screen is displayed.
6.15.1.6 Moving the Cursor
To move the cursor displayed on the ladder screen, use the keys as described in "6.3 Operation Key List".
The following table describes the cursor movement that occurs when each key is pressed.
Key
Up and down arrow keys
This moves the cursor on the ladder screen vertically for one increment.
Left and right arrow keys
This moves the cursor on the ladder screen horizontally in one increment.
This moves the cursor on the ladder screen forward (to the right) in increments of ladders.
→ | key
The cursor does not move in a horizontal line.
This moves the cursor on the ladder screen backward (to the left) in increments of ladders.
| ← key
The cursor does not move in a horizontal line.
Page Up key
This moves the cursor on the ladder screen up one page.
Page Down key
This moves the cursor on the ladder screen down one page.
6.15.1.7 Starting and Stopping the Monitor
The following table describes the timings at which the monitor is started and stopped.
Start monitor
Timing at which the PLC On-board starts and the ladder
screen displays
Timing at which the system transitions to the monitor
menu
Timing at which the system transitions to the ladder
screen
Operation
Stop monitor
Timing at which the system transitions to the edit menu
Timing at which the system transitions to the main menu
Timing at which the system transitions to a screen other than
the ladder screen
Timing at which the system transitions to the Mitsubishi Elec-
tric standard screen
Timing at which the system transitions to the ladder in the FB
by searching
437
IB-1501614-B