M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.17 Device Menus
Operation of key presses
The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key/return menu key
Close
6.17.4.2 Trace Count Setup Screen
Outline
The total number of traces and the number of traces after trigger can be specified.
Total (Default: 1024 times)
After trigger (Default: 512 times)
Note
(1) The settings such as the "No. of traces" and so on are valid after pressing the [SETTING] menu key.
(2) The trace conditions are retained in the NC at the start of tracing.
If you start the on-board and open the sampling trace screen, the screen shows the retained conditions even after the NC
power OFF.
If you set the trace conditions, and then turn OFF the NC power before starting tracing, the previous conditions before the
setting are applied.
(3) The entry settings are disabled during the trace execution. (An error message appears.)
(4) If the value greater than 8192 times is input to the total number and the focus is moved to the other entry field or selection
field, the input value of total number is changed to "8192" automatically.
These transition to the main menu.
This displays the specified screen.
Sets the number of traces between 1 to 8192.
Sets the number of traces after trigger.
The setting value has to be smaller than the number of traces.
521
Operation
IB-1501614-B