Writing Data To Cnc Controller - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
5 Peripheral Development Environment (GX Works2)
5.5 Common Items

5.5.6 Writing Data to CNC Controller

To operate on the CNC controller the data created and edited by GX Works2, write them to the CNC controller. This section
describes how to write data to the CNC controller.
For the user safety sequence, refer to "M800/M80 Series Smart safety observation Specification manual".
(1) Start the operation screen by the following operation on GX Works2.
[Online] -> [Write to PLC]
(2) Select the files to write, and click [Execute] on the following screen.
 To write individual files, select files to be written.
 To write parameters and sequence programs, click [Parameter+Program].
 To write all files, click [Select All].
Note
 [Program Memory/Device Memory] is the only valid option for [Target Memory Setting].
 Since device memory cannot be written to the CNC controller, unselect the checkbox for device memory.
 If an attempt is made to remove the check from the parameter and to write sequence programs while PLC is running,
the prompt "PLC is running. Do you want to force write of the files?" is displayed.
The CNC can only write during RUN from the [Compile] menu; when [Yes] is clicked, writing sequence programs fails
with an error message.
When [No] is clicked, the message "Do you want to write to PLC after remote stop?" is displayed; click [Yes].
IB-1501614-B 88