Writing The Sequence Program To The Cnc Controller; Operation Procedure - Mitsubishi Electric M800VW Series Manual

Plc development

Hide thumbs Also See for M800VW Series:

Table of Contents

M800V/M80V Series PLC Development Manual

5 Peripheral Development Environment (GX Works2)

5.6 Developing Simple Project

5.6.4 Writing the Sequence Program to the CNC Controller

This section describes how to write sequence programs in a simple projects from GX Works2 to the CNC controller

(particularly restrictions and operation specific to this CNC).

(1) This operation writes data to the temporary storage in the CNC (RAM in CNC). Data in temporary storage (RAM in CNC)

are not retained after power OFF. To retain data after power OFF, write sequence programs to the ROM in the CNC

according to "5.6.6 Writing Sequence Programs to ROM in CNC".

 Operating procedure for simple projects (without labels)

The operating procedure for when labels are not used is described below.

(1) Start the operation screen by the following operation on GX Works2.

[Online] -> [Write to PLC]

(2) Select [Program Memory/Device Memory] in [Target Memory Setting] of PLC data on the following screen.

Select write sequence program files, and click [Execute].

Use [Remote Operation] under [Related Functions] to instruct the PLC to RUN or STOP.

 [Program Memory/Device Memory] is the only valid option for [Target Memory Setting].

IB-1501614-B