Verify External File Screen; Outline; Screen Display Items - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.14 External File Operation Menus

6.14.7 Verify External File Screen

6.14.7.1 Outline

This compares the PLC data (sequence programs and parameters) stored in external devices with PLC data (sequence
programs and parameters) stored in projects.
When operation mode of a project is GX Works2, "Verify External File Screen" cannot be displayed and files cannot be
verified. For details on the operation mode, refer to "6.1.3 Operation Mode of Project".

6.14.7.2 Screen Display Items

The following table describes the screen display items for the verify external file screen.
Item name
Connected NC name
Current project No.
Current project label
Alarm message
Left arrow key
Software keyboard
Verify source (NC)
Verify destination (external)
Top of step range
End of step range
IB-1501614-B
Display state
This displays the name of the connected NC.
This displays the current project number.
This displays the project label.
Alarm messages are displayed when alarms occur.
This is displayed when enabled.
This is displayed only when parameters are enabled.
This displays the PLC data stored in the current project.
This displays nothing if there is nothing stored.
This displays PLC data stored in the selected on the select external proj-
ect screen.
This displays nothing if there is nothing stored or no PLC data has been
selected.
This displays the top step number in the step range.
A zero is displayed if there is nothing stored.
This displays the end step number in the step range.
A zero is displayed if there is nothing stored.
426