Abnormal Operation; Closing The Program Settings Screen - Mitsubishi Electric M800VW Series Manual

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.18 Parameter Menus
(12) The following message screen displays when the PLC is running.
(a) Pressing the [NO] menu key displays the following error message.
Closing the error message returns to the program settings screen.
(b) Pressing the [YES] menu key closes the message screen and executes the program settings. The following message
displays after the settings are complete.
Press the [YES] menu key restarts the PLC stopped to complete the settings and closes the message screen.
Pressing the [NO] menu key closes the message screen without restarting the PLC.
(13) The complete message displays if the program settings complete without error. Closing the complete message returns
the system to the program settings screen.

6.18.2.7 Abnormal operation

This information describes the details of error messages displayed on the program settings screen and the corrective action
thereof.
Error message
Failed to obtain the maximum number of
registration programs.
Please set it within the PLC specified
range.

6.18.2.8 Closing the Program Settings Screen

Use any of the following methods to close the program settings screen.
Methods to close the screen
Press the [CLOSE] menu key.
Press the left arrow key.
Press the [ESC] key on the software keyboard.
IB-1501614-B
Error details
This message appears when you use the
PLC on-board of version C0 or later to
connect to the NC of version B2 or earlier.
562
Remedy
Update the connected NC to version C0
or later.
Note however that the program setting
can be executed within the PLC specifica-
tion ranges.