Mitsubishi Electric M800VW Series Manual page 559

M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.17 Device Menus
Screen display items
The following table describes the screen display items on the trace data setup screen.
Item name
Connected NC name
Current project No.
Current project label
Alarm message
Left arrow key
Software keyboard
Bit device
Word device
Addition data
Enabled/disabled state of menu keys
The following table describes the conditions upon which menu keys displayed on the trace data setup screen are enabled/
disabled.
The menu keys which are not described in the following table are always enabled.
Menu name
Add monitor device
Select data
Status during screen displays
The following table describes the status when the trace data setup screen is displayed.
Item name
Bit device
Word device
Add time
Operation of key presses
The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key
Bit device setup
Word device setup
Add time
Add monitor device
Setting
Insert Row
Delete Row
Select data
Close
IB-1501614-B
This displays the name of the connected NC.
This displays the current project number.
This displays the project label.
Alarm messages are displayed when alarms occur.
This is displayed when enabled.
This is displayed only when parameters are enabled.
This displays the specified bit device and the type.
This displays the specified word device.
This displays the add time status.
Condition upon which it is enabled/disabled
Enabled when a monitor device is registered.
Enabled when the focus is applied to the Bit device (type).
This is left blank.
This is left blank.
This is displayed with the check box not selected.
Refer to "Closing the trace data setup screen".
The focus is applied to the bit device field.
The focus is applied to the word device field.
The focus is applied to the Addition data field.
This changes the Add time selection when the focus is already applied.
This adds the device registered in the entry device monitor to the bit device field or the word de-
vice field.
Refer to "Trace data setup ".
This inserts a blank line at the cursor position.
Lines are not inserted when a device is already set at the last line.
This deletes a line at the cursor position and moves remaining data up.
Cursor position
Bit device field
("DEVICE" column)
Bit device field
("TYPE" column)
Word device field
("DEVICE" column)
Add time field
Refer to "Closing the trace data setup screen".
Display state
Operation
Operation
Device entry field is displayed.
Type selection can be changed.
Device entry field is displayed.
This changes the selection.(check/uncheck)
534