Installing When Starting The Got; Installing Using The Data Control Function (Utility) - Mitsubishi Electric GOT SIMPLE Series Operation Manual

30.1

Installing when starting the GOT

When installing with an SD card
1.
Power OFF the GOT, and install the SD card where the BootOS, system application or project data is stored in the SD
card interface of the GOT.
2.
Power on the GOT. While touching the lower right side of the GOT screen, power on the GOT. (1-point press installation
function)
3.
The BootOS or system application is installed in the built-in flash memory. Do not pull out the SD card or power OFF the
GOT.
4.
The GOT restarts automatically after the installation is completed.
5.
After confirming normal restart, confirm that the SD card access LED is not lit, and remove the SD card from the SD card
interface of the GOT.
30.2

Installing using the data control function (Utility)

Operation procedure
30 BootOS and System Application Installation Using Data Storage
390
30.1 Installing when starting the GOT
Touch
[Data copy].
1.
Power OFF the GOT, and attach the SD card which
stores the basic system application and communication
driver to the GOT.
2.
While touching the upper left corner of the GOT screen,
power ON the GOT.
3.
When the screen shown on the left appears, select the
[Data copy].
For details of install, refer to the following.
Page 310 Data Copy