M800V/M80V Series PLC Development Manual
5 Peripheral Development Environment (GX Works2)
5.6 Developing Simple Project
Note
If an attempt is made to remove the check from parameter and write sequence programs during PLC run, the following
message is displayed.
"PLC is running. Do you want to force write of the files?"
The CNC only supports writing during RUN from the [Compile] menu; if [Yes] is clicked, an error dialog is displayed and
sequence programs are not written.
Click [No] to display the following message, and then click [Yes].
"Do you want to write to PLC after remote stop?"
129
IB-1501614-B