Mitsubishi Electric M800VW Series Manual page 100

M800V/M80V Series PLC Development Manual
5 Peripheral Development Environment (GX Works2)
5.4 Preparation
 For user safety sequence
Set the following items in the order of the list.
Item
PC side I/F
Network No.
Station No.
Protocol
PLC side I/F
CPU mode
Ethernet: direct port connection and connection
via hub selection
IP address
IP Input Format
Other Station Setting
Check at communication time (sec.)
Retry Times
Multi CPU
Select the first machine for the user safety sequence 1.
Select the first machine for the user safety sequence 2.
(*1) Double-click [Ethernet Board] to display the setting item.
(*2) Double-click [Ethernet Module] to display the setting item.
(*3) Double-click [Other Station (Single network)] to display the setting item.
[Transfer Setup Connection 1 screen]
When the above setting is completed, press [Connection Test].
If connection is successful, the message "Connected with Q26UDHCPU" is displayed with the multi-CPU connection status
below the message. This indicates the connection status of each project.
Setting
Ethernet Board
1
1
TCP
CPU unit
QCPU (Q mode)
Connection via hub
IP address of CNC
DEC.
No other station designated
Arbitrary time (approximately 10 seconds and
longer)
0
75
Remarks
(*1)
(*1)
(*1)
(*2)
(*2)
(*2)
(*2)
(*3)
(*3)
IB-1501614-B