M800V/M80V Series PLC Development Manual
6 Explanation of Built-in Editing Function (PLC On-board)
6.13 NC File Operation Menus
6.13.3.3 Enabled/Disabled State of Menu Keys
The following information describes the conditions upon which menu keys displayed on the opened screen are enabled/
disabled.
The menu keys which are not described in the following table are always enabled.
Menu name
Select/cancel all data
Parameter + Program
PLC messages
Open
Select/cancel data
6.13.3.4 Status during Screen Displays
The following table describes the status when the opened screen is displayed.
Item name
List
This is the default focus position when the screen is displayed.
This displays the PLC data stored in the current project.
Check status changes depending on the operation mode as follows:
GX Developer mode
Not checked
GX Works2 mode
Device comment is not checked.
Other than device comment is checked.
6.13.3.5 Operation of Key Presses
The following table describes the operation of each menu key and the keys on the NC keyboard when pressed.
Item name
Left arrow key
List
Select/cancel all data
Parameter + Program
PLC messages
Open
Select/cancel data
Close
Condition upon which it is enabled/disabled
Enabled when operation mode of a project is GX Developer and selectable PLC
data has been added to the list
Enabled when operation mode of a project is GX Developer and selectable PLC
data has been added to the list
Enabled when selectable PLC data has been added to the list
Enabled when selectable PLC data has been added to the list
Enabled when operation mode of a project is GX Developer and selectable PLC
data has been added to the list
Operation
Refer to "6.13.3.7 Closing the Opened Screen".
The focus is applied to the list.
This checks/unchecks the check boxes for all data in the list.
This checks the check boxes for parameters and programs in the list. This does
not include PLC messages however.
This checks the check boxes for the PLC messages in the list.
Refer to "6.13.3.6 Opening PLC Data".
This selects/deselects the check boxes for the selected data in the list. This op-
eration can also be performed with the [SP (space)] key.
Refer to "6.13.3.7 Closing the Opened Screen".
353
Operation
IB-1501614-B